SRX4600 Services Gateway Quick Start
9. (Optional) Configure the name of the device. If the name includes spaces, enclose
the name in quotation marks (“ ”):
[edit]
admin@# set system host-name host-name
10. Configure the IP address and prefix length for the management interface on the
device:
[edit]
admin@# set interfaces fxp0 unit 0 family inet address
address/prefix-length
11. Configure the default route:
[edit]
admin@# set routing-options static route 0.0.0.0/0 next-hop
gateway
12. Check the configuration for validity:
[edit]
admin@# commit check
13. Commit the configuration to activate it on the device:
[edit]
admin@# commit
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including
translations, see the SRX4600 Services Gateway documentation at
https://www.juniper.net/techpubs/a077.html .
WARNING: Failure to observe these safety warnings can result in personal injury
or death.
z Permit only trained and qualified personnel to install or replace device components.
z Perform only the procedures described in this quick start and the SRX4600 Services
Gateway documentation. Other services must be performed only by authorized service
personnel.
z Before installing the device, read the planning instructions in the SRX4600 Services
Gateway documentation to make sure that the site meets power, environmental, and
clearance requirements for the device.
z Before connecting the device to a power source, read the installation instructions in the
SRX4600 Services Gateway documentation.
z The services gateway weighs approximately 22 lb (9.97 kg). Manually installing the
device in a rack at a height above 60 in. (152.4 cm) requires two persons; one to lift the
device and the second to install the mounting screws. To prevent injury while lifting,
keep your back straight and lift with your legs, not your back.
z If the rack has stabilizing devices, install them in the rack before mounting or servicing
the device in the rack.
z Before installing or after removing an electrical component, always place it
component-side up on an antistatic mat placed on a flat, stable surface or in an
antistatic bag.
z Do not work on the device or connect or disconnect cables during electrical storms.
z Before working on equipment that is connected to power lines, remove jewelry,
including rings, necklaces, and watches. Metal objects heat up when connected to
power and ground and can cause serious burns or become welded to the terminals.
Power Cable Warning (Japanese)
The attached power cable is only for this product. Do not use this cable for another
product.
Contacting Juniper Networks
For technical support, see http://www.juniper.net/support/requesting-support.html .
To Previous Page
Loading...
