SRX100 Services Gateway Quick Start
Use the instructions in this quick start to help you connect the SRX100 Services
Gateway to your network. For details, see the SRX100 Services Gateway Hardware
Guide at http://www.juniper.net/techpubs/a059.html
.
SRX100 Services Gateway Front Panel
SRX100 Services Gateway Back Panel
SRX100 Services Gateway Models
The following two models of SRX100 Services Gateways are available:
Connecting and Configuring the SRX Series Device
Use the instructions below to connect and set up the SRX100 Services Gateway to
protect your network. Refer to the LEDs on the front of the device to help you determine
the status of the device.
Task 1: Overview
The SRX100 Services Gateway is a security device that requires these basic
configuration settings to function:
Interfaces must be assigned IP addresses.
Interfaces must be bound to zones.
Policies must be configured between zones to permit or deny traffic.
Source NAT rules must be set.
The device has the following default configuration set when you power it on for the first
time. To be able to use the device, you do not need to perform any initial configuration.
Factory-Default Settings:
Factory-Default Settings for Security Policies:
Factory-Default Settings for NAT Rule:
Callout Description Callout Description
1 Power button 4 USB port
2 LEDs (ALARM, POWER,
STATUS, HA)
5 Console port
3 Reset Config button 6 Fast Ethernet ports
Callout Description
1 Lock slot for security cable
2 Grounding point
3 Cable tie holder
4 Power supply input
Device DDR Memory
SRX100B 512 MB
SRX100H 1 GB
Port Label Interface Security Zones DHCP State IP Address
0/0 fe-0/0/0 untrust client unassigned
0/1 to 0/7 fe-0/0/1 to fe-0/0/7 trust server 192.168.1.1/24
Source Zone Destination Zone Policy Action
trust untrust permit
trust trust permit
untrust trust deny
Source Zone Destination Zone Policy Action
trust untrust source NAT to untrust zone
interface
To Next Page
Need help?
General
