Jura IMPRESSA A9 One Touch - Important Safeguards; Basic Safety Precautions

4
IMPRESSA A9 One Touch – Quick Reference Guide
T Rinse all the parts under running water.
If there are severely dried-on milk residues,
firstly immerse the individual parts in a
solution of 250ml cold water and 1 capful of
JURA milk system cleaner. Then rinse the
parts thoroughly.
T Fit the air intake pipe.
T Reassemble the milk system. When doing
this, note the numbering of the individual
parts.
T Fit the assembled individual parts back in
the dual spout and press it firmly.
T Fit the dual spout on the machine. It will
click into place audibly.
1
2
3
9
Inserting and activating the filter
Your IMPRESSA no longer has to be descaled if you
are using the CLARIS Blue filter cartridge. If the
water hardness is 10°dH or more, we recommend
using the filter cartridge. If you do not know the
hardness of your water, you can find this out first
(see Chapter 1 ‘Preparing and using for the first
time – Determining the water hardness’).
If you did not activate the filter cartridge the first
time you used the machine, you can do this now
as follows.
E Perform the ‘inserting the filter’ operation
without any interruptions. This will ensure
that your IMPRESSA always produces its
best.
Precondition:The start screen is displayed.
T Touch the Menu symbol t for about
2 seconds.
T Touch ‘>’ (bottom right) several times until
the programme item ‘3/4’ is displayed.
T Touch ‘Use filter’.
‘Use filter’
T Touch ‘Active’.
T Touch ‘Save’.
‘Saved’ appears briefly on the display.
‘Insert filter’
T Remove the water tank.
T Open the filter holder and insert the filter
cartridge into the water tank, exerting slight
pressure.
T Close the filter holder. It will click into place
audibly.