Jura IMPRESSA J5 Quick Reference Guide

9
IMPRESSA J5 – Quick Reference Guide
l Empty the container under the Connector System
©
.
FILL WATER TANK
l Rinse the water tank thoroughly and fill it with cold, fresh
mains water.
l Put the water tank back in.
PRESS RINSE – The maintenance button h lights up.
l Place a container under the Connector System
©
.
h l Press the maintenance button.
This causes water to flow out of the Connector System
©
.
The operation stops automatically –
EMPTY TRAY.
l Empty the drip tray and coffee grounds container and put
them back into the machine.
l Replace the nozzle.
The descaling operation is now complete.
The IMPRESSA heats up and is ready for use again.
o If the descaling operation stops unexpectedly, rinse the water
tank thoroughly.
To ensure that the Professional Cappuccino Frother works perfectly,
you should rinse it with water after every milk preparation.
o The IMPRESSA will not prompt you to rinse the Professional
Cappuccino Frother.
l Remove the milk pipe from the milk carton/bottle or the
milk container.
l Fill the receptacle with 250 ml of fresh water and immerse
the milk pipe in it.
l Place a receptacle under the Professional Cappuccino
Frother.
l Turn the selection lever to the milk or milk foam
position.
k l Press the steam button.
HEATING
READY
Rinse Professional
Cappuccino Frother

Jura IMPRESSA J5 Specifications

General

Type	Coffee
Dimensions (WxDxH)	285 x 433 x 342 mm
Product type	Espresso machine
Water tank capacity	2.1 L
Coffee beans capacity	250 g
Maximum operating pressure	15 bar
Cord length	1.1 m
Product color	Black
Illuminated on/off switch	Yes
Multi beverage	No

Weight and Dimensions

Weight	10750 g