Just Motion Control 2DM860 - Page 23

Shenzhen Just Motion Control Electro-mechanics Co., Ltd 0755-26509689
- 23 -
standstill current
current is set to be half of the selected dynamic
current or other current,
Percentage of
standstill current
This parameter is set the percentage of standstill
current.
Speed
smoothness
This parameter is set to control the smoothness of
the speed of the motor while acceleration or
deceleration, the larger the value, the smoother the
speed in acceleration or deceleration.
1
2
10
…
0
Enable of
position memory
This parameter is set to enable the function of
position memory. 0 means disable, while 1 means
enable. If set 1, the 2DM860 can remember the
position of motor in the next time of power on.
User-defined
resistance of
motor
This parameter is set the resistance of motor. 0
means 2DM860 gets the resistance by control
algorithm of Parameter auto-setup, while 1 means
2DM860 gets the resistance through user sets.