Juuko C2 User Manual

12
Chapter 4: Troubleshooting
(English)
Standard settings
- Corrosion on the battery
terminals.
- Low battery.
- Damage batteries.
- Transmitter is not
communicating with the
receiver.
- Push button damaged.
-Clean the battery terminals .
- Replace the batteries.
- Check the power supply
of the receiver.
- Check the fuse in the
receiver
- Contact the dealers.
Failure Analysis
Solution
LED Signal
SHORT
LONG
LED red LED green
LED red
LED green
LED red
LED green
LED red
LED green
Transmitter
Receiver
Should an error occur, the LED of the receiver will indicate the cause.
-RF error
-RF error
-
Receiver is not powered.
-Check the antenna and
make sure it is not loose.
-Change a new RF module.
-Contact dealer
-Check the antenna and
make sure it is not loose.
-Change a new RF module.
-Contact dealer
-
Check the fuse.
-Check the power supply.
Failure Analysis
Solution
LED red
LED green
LED green
LED green
LED Signal
SHORT
LONG
LED red
LED red
The receiver is receiving data.
(K200~K808)12C&20C-EN01
Radio remote control system
BASIC INSTALLATION INSTRUCTIONS
【C2/C2E/C2Q/C2EQ】
【HV】CE
K200 K808
K400 K1000
K600 K1200
K800

Juuko C2 Specifications

General

Brand	Juuko
Model	C2
Category	Remote Control
Language	English