Page 12 of 13
To use the built-in analog converter to drive an external device, you should use special Y-form
MIDI cable (optional). One end of this cable is plugged in sampler, but another is splitted to MIDI
IN and MIDI OUT. Connected MIDI OUT part of cable to MIDI IN of the synthesizer you want to
con-trol. If you want to control more than one external MIDI synthesizer, then you need to connect
MIDI THRU of the first controlled MIDI synthesizer to MIDI IN on the second, using normal MIDI
cable. If the external synthesizers are more than two, then you need to connect MIDI THRU of the
second to MIDI IN of the third and so to the end of the chain.
Extended MIDI Connector Functions
MIDI connector have same extendent function
like: combined MIDI IN/OUT, and power out
for Juzisound Accordeon MIDI systems.
Pinout:
1. +5 Volt power out for Juzisound Accordeon MIDI System. Alsu (MIDI OUT+).
2. GND power out for Juzisound Accordeon MIDI System.
3. MIDI OUT-. Connect trought 220 Ohm resistor to pin 1 (MIDI OUT+).
4. MIDI IN+. Optoisolated MIDI Input - positive.
5. MIDI IN-. Optoisolated MIDI Input - negative.
6. GND. Common GND of device.
To Next Page
