Page 11 of 13
Breath controller Connection
[Analog IN] connector on the rear panel of the
sampler is used to connect an analog controllers.
Analog controller means the following:
- breath controllers, volume or expression pedals,
simple potentiometers or any other type of
device, that produces an analog signal.
Analog input have hardware configurable
amplifier and offset settings, controled by
sampler menu. To connect analog controller,
use 3.5" stereo jack.
Pinout of connector is user adjustable, and possible configuration are shown in next images.
Analog input produce power for analog controller. Work voltage is +5V / 50 mA. Sampler have
power short cirquit protection, and manual switch for power polarity settings. To switch between 2
availabe power polarity scheme, move switch LEFT or RIGHT. Juzisound Breath
Controller work in LEFT position. If you select wrong scheme, or have short cirquit in cable,
sampler will stop power and produce error message on display. To restore power, simple press any
button of device or USB keyboard. This will clear error message, and restory power on connector.
To Next Page
