JVC A-GX1 - Removal and Reassembly Procedures; Main P.C. Board Removal Steps; Reassembly Screw Type Guidance

4-GX1/A-GX1B
2. Removal and Reassembly Procedures
2-(1) Removal of the Main P.C. Board
1. Remove the metal cover.
2. Remove screws (1) and @ on the P.C. board
3. Remove the pin jack on the rear panel and fixing screws @) ~ () of the speaker terminal.
4, Remove screws @) ~ © and plastic rivet © to set the front panel free.
5. Remove all the screws @) ~ (5 except the foot at the bottom.
Note:
As three types of fixing screw are
used for the base, make sure the
screws are correct when reinstalling.
1-3 (No. 2810)