20
6 After choosing “Internet Protocol Version 4 (TCP/Ipv4)”, select
“Properties”.
7 Proceed to 8) for LAN connection via router and complete the
setup in 12).
Proceed to 13) if the projector and PC are directly connected by
LAN cable and complete the setup in 16).
8 Check the boxes for “Obtain an IP address automatically” and
“Obtain DNS server address automatically”.
=> Click “OK”, and then close all the windows by clicking the “x”
button.
9 Turn on the power of the projector.
Select “MENU” => “Function” => “Network”, and proceed to 10).
10 Set “DHCP Client” to “On”
After choosing “Set”, select “Yes” in “Apply network setting?”
11 Write down the value in “IP Address” (192 168 0 2 in the
example) after returning to the screen in 10).
12
Start the
“
JVC Projector Calibration Software
”
on your PC, and
select “Setting” on the right side of the screen.
Enter the value from 11) in the
“
IP address
”
field on the screen on the
right.
Click “CHECK”. If “OK” appears on the right of the button, complete
the setting by clicking the “OK” button at the bottom right corner.
To Next Page
Loading...
