14
Initial Setup W
Initial Setup W
izard
izard
After the STANDBY/ON is pressed for the first time to
turn on the unit or after factory setting (See page 16),
the Initial Setup Wizard function sets the Language,
Channels and Clock step-by-step until the setup is
complete.
1. Use v / V to select a language for the Setup
menu and information display then press ENTER.
2. Check your antenna connections.
Press B to move next step.
3. Select the [Tuning Band] option then press B .
TV is for over-the-air antenna reception.
CATV is for cable subscribers.
4. Press ENTER to begin the channel search.
You can skip the analog channel scanning by
pressing B.
5. Enter the necessary information for year, date and
time.
b / B (left/right): Moves the cursor to the
previous or next column.
v / V (up/down): Changes the setting at the
current cursor position.
Press ENTER to confirm your setting.
6. Press ENTER to exit the menu.
Note:
You can reset the Initial Setup Wizard from the
[Factory Set] in the setup menu. (see page 16).
To Next Page
Loading...
Need help?
General
