36
Timer Recording Troubleshooting
Even though the timer is set, the recorder will not
record when:
• There is no disc (or tape) loaded.
•Anon-recordable disc (or tape) is loaded.
• Disc Protect is set to [ON] in the Disc menu
(see page 21).
• There are already 99 titles (DVD-RW, DVD-R,
DVD-RAM), 49 titles (DVD+RW, DVD+R)
recorded on the disc.
You cannot enter a timer program when:
•Arecording is already underway.
• The time you’re trying to set has already
passed.
• There are already 16 timer programs set.
If two or more timer programs overlap:
• The earlier program takes priority.
• When the earlier program finishes, the later
program starts.
• If two programs are set to start at exactly the
same time, the program entered first takes
priority.
If the disc is damaged, the recording may not
complete successfully. In this case even though the
Check field shows [Rec. OK], it may not be.
Note:
Recording programs that are blocked through
Parental Lock or TV Ratings will present the following
message: "Cannot Record-No Input Signal". Please
disable/ adjust the TV Rating (See page 19) or the
Parental Lock (See page 18) before recording the
program when you want to record.
To Next Page
Loading...
Need help?
General
