JVC FS-GD7 - Picture Tone and Clock Configuration; Detailed Picture Tone Adjustments; System Clock Setting Procedure

17
To adjust the picture tone
1
Select “USER1” or “USER2.”
• Follow steps 1 and 2 explained on page 16.
2
Select a parameter you want to adjust.
3 Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the screen,
press VFP again.
Setting the Clock
Without setting the built-in clock, you cannot use the Daily
Timer (see page 30) and Sleep Timer (see page 18).
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL.
1
Activate the clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected (see page 30).
2
Adjust the hour.
3
Adjust the minute.
Now the built-in clock starts working.
To check the current clock time during play
• While playing a DVD or MP3, you cannot check the
current clock time (see page 9).
GAMMA Adjust if the neutral color is bright or
dark (–3 to +3).
BRIGHTNESS Adjust if the entire picture is bright or
dark (–8 to +8).
CONTRAST Adjust if the far and near positions
are unnatural (–7 to +7).
SATURATION Adjust if the picture is whitish or
blackish (–7 to +7).
TINT Adjust if the human skin color is
unnatural (–7 to +7).
SHARPNESS Adjust if the picture is indistinct
(–8 to +8).
Remote
ONLY
Clock
Source information
(at the same time)
FS-GD7[J]_EN.book Page 17 Tuesday, April 5, 2005 10:45 AM