D.S.C. RECORDING (GR-D93/D73 only)
DIGITAL STILL CAMERA (D.S.C.) RECORDING & PLAYBACK (GR-D93/D73 only)
EN 19
MasterPage: DSC_Right
Still images can be dubbed from a tape to a memory
card.
1 Load a cassette. (墌 pg. 10)
2 Load a memory card. (墌 pg. 10)
3 Set the VIDEO/MEMORY Switch to “VIDEO”.
4 Set the Power Switch to “PLAY” while pressing down
the Lock Button located on the switch.
5 Set “ COPY” to “ON”. (墌 pg. 25, 28)
6 Press 4/9 to start playback.
7 At the point you want to dub, press 4/9 again to
engage Still Playback.
8 To dub the image, press SNAPSHOT.
● The “” indication appears during dubbing.
● The selected image is stored in the memory card.
NOTES:
● If SNAPSHOT is pressed in step 8 when a memory card is
not loaded, the message “COPYING FAILED” is displayed.
● If an image recorded on the tape using “WIDE MODE”
(墌 pg. 26) is dubbed to a memory card, the WIDE mode
identifying signal is not dubbed with it.
● To use Playback Special effects with a video image you
wish to dub, perform up to step 8 using the remote control
(provided). (墌 pg. 16)
● Images are dubbed in 640 x 480 pixels.
Dubbing Still Images Recorded On A Tape
To A Memory Card
GR-D73US.book Page 19 Thursday, November 20, 2003 10:50 AM
To Next Page
Loading...
