JVC GR-D350UC

1-20 (No.YF123)
SECTION 5
TROUBLE SHOOTING
5.1 SERVICE NOTE
[13]
3-2-4
[9]
VF1 VF2
[1] [2] [3] [4] [5] [6] [7] [8]
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 - 17 18 19 20 21 22 23 24 25 26
FA1-1 FA2-1 FA2-2
aba
FA2-3 FA2-4
FA3
FA4
e
ad
-
[9] [10] [11] [12] [13] [14] [15] [16]
27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43
FA5 FA6 FA7 FA8 FA9
ac
FA10
- -
[4]
1 2 3 4 1 2 3 4 5 6
1 2 3 4 5 6 7 8 9
3-2-3
a
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
Symbol No.
Removing order of screw
Place to stick screw
Reference drawing (Fig.No.)
Screw tightening torque
CABINET PARTS AND ELECTRICAL PARTS(1) [4]MONITOR ASSY [9]VF ASSY CABINET PARTS AND ELECTRICAL PARTS(2)
NOTE: 㧝)㧖and㧖㧖 (This mark shows where to attach the screws) : Do not reuse the screws because the screw lock bond was applied to prevent the screws from loosening. Prepare the specified screws and use them in place of the removed screws. 㧞)Tightening torque for the screws ࡮There are setting limits of the torque value for the torque driver. If the value exceeds the setting value, take it as a rough measurement (reference value),
and tighten the screw manually. ࡮The specified torque value is a recommended value of the initial assembly. Therefore, set the value below the specified torque value in the assembling procedure. Be careful not to break either the screws or the screw holes.
ޓa㧦 0.098N㨯m (1.0kgf㨯cm)ޓޓb㧦 0.196N㨯m (2.0kgf㨯cm)ޓޓc㧦 0.088N㨯m (0.9kgf㨯cm)ޓޓd㧦 0.147N㨯m (1.5kgf㨯cm)ޓޓe㧦 0.069N㨯m (0.7kgf㨯cm)
[13]OP BLOCK ASSY/CCD BOARD ASSY