C+settoho+der Loading/llnioadingACassette
Erase protection
switch*
PUSH HERE
OPEN/ErECT Switch
Casse_e cover
Make sure the
window side is
facing out.
* To Protect Valuable Recordings,..
.... slide tile erase prr)tection switch on the
back of the tape in the direction of "SAVE".
This prevents this tape from being recorded
over. If you decide later that you do want
to recrlrd on this tape, slide the switch back
to "RE(" before loading the tape.
The camcorder needs to be powered up to load or eject a
cassette.
OPEN CASSETTECOVER
Slide OPEN/EJECT in tile direction (>tthe arrow then
swing the cover open until it locks. The holder opens
automatically.
• Dr) not touch internal components.
INSERT/REMOVE TAPE
Insert or remove a tape and press "PUSH HERE" to
close the cassette holder.
• Once the cassette holder is closed, it recedes
automatically. Wait until it recedes completely
before closing the cassette covet:
oWhen tile battery's charge is low, you may not be
able to close the cover. Do not apply force. Replace
the battery with a fully charged one before
continuing.
CLOSE CASSETTECOVER
(lose tile cassette cover firmly uittJJ it locks into
place.
Approximate recording time
Recording
Tape
SP
mode
LP
DVM-30 30 rain. 45 rain.
DVM-60 60 rnin. 90 rnin.
NOTES:
• It takes a f_w second_ lbr tile cassette holder to open. Do not apply force.
• If you wait a few second_ arid the cassette holder does riot operl, close tile cassette cover and try a_ain. If the
cassette hohler still does not operl, turn tile camcorder off therl orl agairl.
• If the tape does not Ioadproperly, open the cassette cover fully and remove the cassette. A few minutes later,
insert it again.
• When the camcorder is suddenk/moved from a cohl place to a warm environment, wait a short time before
opening the cover.
• (losing the cassette cover bel_re the cassette holder comes out may cause damage to the c amcorde_:
• Even wherl the camcorder is switched ofl_ a cassette can be loaded or urlloaded. After tile cassett_ holder is
closed with tile camcorder switched ofl_ however, it may not recede. It is recommended to turn the power orl
bek>re Ioadirlg or unloading.
• _Vherl resuming recording_ once yOtl oper} the cassette cover a blarlk portion will be recorded on tile tape or
a previously recorded scene +viii be erased (recorded over) regardless of whether tile cassette holder came
out or not. See page 27 lbr inlbnnation about recordirlg from the middle of a tape.
To Next Page
Loading...
Need help?
General
