71
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
CONNECT CAMCORDER TO TV OR
VCR
( onnect as shown in tile illustration (g7 pg. 70).
If Using A VCR . . . go to step 3.
lt not . . . go t_)step 4.
CONNECT VCR OUTPUT TO TV
INPUT
Refer to your V(R's instruction manual.
SUPPLY POWER
Turn on tile camcorder, tile V(R and the TV.
SELECT MODE
Set the VCR t(> its AUX input mr)de, and set the
TV to its VIDEO mode.
To choose whether or not the following displays
appear on the connected TV. . .
Date/Time, Time (ode
.... set to "ON" or "OFF" in the Playback Menu
C_/ pg. B4).
• Playback Sound Mode Display
.... set the (-)peration Switch to "[]", then set the
Power Switch to the camera position
(" _ ", "5 S" or " _") while pressing
down the Loci< Button. PressMENU/SET and
set "ON SCREEN" in the Date/Time Menu
('_/ pg. }6 3% to "ON" or "OFF". Then, set
the Power Switch bacl<to "I'llml_l,'.
NOTES:
• It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack. (_ / pg. It)
• The S-Video cable and Audio/Vkleo cable (RCA
plug to RCA plug) are optional. Be sure to use the
following:
. S-Video cable: YTU94146A
Audio/Vkteo cable (RCA plug to RCA plug):
YTU94147A
Consult the ]VC Service Center described on the
sheet included in the package for details on their
availability.
• Never connect any other Audio/Video cable tharl
the provided Audio/Virleo cable hnirli-plug to R( A
phlg) to the camcorder'_ AV OUT connector.
• When using the cable_, make sure you connect the
end of the cable with the core filter to the
camcordec The core filter reduces interference.
• T_>monitor the picture and sound from tile
calYIcorcler without inserting a tape or
MultiMediaCard, set the camcorder's Power
Switch to "_ ", "_S" or "[_ "; then set your
TV to the appropriate input mode.
• Make sure you adjust tile TV sourld volume to its
mirlin_un_ level to avoid a sudden burnt of sourld
wherl tile camcorrler is turned on.
• If you have a TVor speakem that are not _pecially
shieMed, do not place the _peakem adjacent to the
TV as interference will occur in tile camcorrler
playbacl< picture.
• To I<eep the camcorder% display from appearing on
the TV screen during pL_ybacl<, set "INDICATION"
to "OFF" in the Playback Menu (_ / pg. _4) and
press DISPLAY orl tile remote control.
• While the Audio/Video cable is connected to the
AV OUT connect_r, sourld cannot be heard from
the _peaket:
To Next Page
Loading...
