Remove.
OPEN/ElECT Switch
IECT
Bottom of
viewfinder Blower brush
Gap
O
NOTES:
• Av_id usin_ strains cleaning agents such as
benzine or a/_ ohol.
• Cleaning should be done only after the
batter), pack has been removed or other
power unit, have been disconnected.
€ Mold may form if the lens is left dirt),.
• Wherl using a cleaner or chemically treated
ck)th refer to the cautiorls of each pro)duct.
After Use
Turn (_ff the can/corder.
Slide down OPEN/EJECT in the direction of the
arrow, then swing the cover open until it locks. The
cassette hr)lder opens auton/atically. Remove the
cassette.
Press "PUSH HERE" to close the cassette cover.
Open the card cr)ver, then press EJECT. The
MultiMediaC ard is disengaged from the camcorder.
Ren/ove the MultiMediaCard.
Close the card cover.
Slide down BATT. RELEASE and remove the battery
pack.
CleaningTheCmc0rder
CLEAN EXTERIOR
Wipe gently with a s()ft cloth.
• Put cloth in diluted n/ild soap and wring it well to
wipe off heavy dirt. Then wipe again with a dry
cloth.
CLEAN LCD MONITOR
Wipe gently with tile provided cleaning cloth or a
commercially available soft cl<lth. Be careful not to
damage the monitor. (lose the L(D monitor.
CLEAN LENS
Blow it with a blower brush, then wipe gently with
lens cleaning paper.
PULL OUT VIEWEINDER FULLY
CLEAN VIEWFINDER
Slide tile cover in tile direction of the am)w O Insert
a lens bl_wer or a soft cl_th into the gap at the
bottom of the viewfinder and clean the interior of the
viewfinder with it O.
PUSH VIEWFNNDER BACK IN
Close the cover until it locks in place. Tilt the
viewfinder horizontally, and push it back in.
To Next Page
Loading...
