EN 55
Master Page: Right
Still images can be dubbed from a tape to a memory
card.
1 Load a cassette. (墌 pg. 16)
2 Load a memory card. (墌 pg. 17)
3 Set the Playback Mode Switch to “VIDEO”.
4 Set the Power Switch to “P” while pressing
down the Lock Button located on the switch.
5 Set “ COPY” to “ON”. (墌 pg. 33, 39)
6 Press 4·9 to start playback.
7 At the point you want to dub, press 4·9 again to
engage Still Playback.
8 To dub the image, press SNAPSHOT.
● The “ ” indication appears during
dubbing.
● The selected image is stored in the memory
card.
NOTES:
● If SNAPSHOT is pressed in step 8 when a memory
card is not loaded, the message “COPYING
FAILED” is displayed.
● If an image recorded on the tape using “DV
WIDE” (墌 pg. 36) is dubbed to a memory card,
the WIDE mode identifying signal is not dubbed
with it.
● To use Playback Special effects with a video image
you wish to dub, perform up to step 8 using the
remote control (provided). (墌 pg. 58)
● Images are dubbed in the following image sizes:
Scenes recorded in HI-RES mode: 848 x 480
pixels
Scenes recorded in PS50 mode: 848 x 480 pixels
(16:9)/640 x 480 pixels (4:3)
Scenes recorded in DV mode: 640 x 480 pixels
Dubbing Still Images Recorded On
A Tape To A Memory Card
Power Switch
SNAPSHOT Button
Lock Button
MENU Wheel
Play/Pause Button (4·9)
Playback Mode Switch
ADVANCED FEATURES
GR-PD1PAL_07Advanced.fm Page 55 Thursday, July 17, 2003 10:00 AM
To Next Page
Loading...
