JVC GR-PD1 - Using the Camcorder as a Webcam

66 EN
Master Page: Left
This camcorder can be used as a WebCam via USB
connection.
* When connecting the cable, open the cover.
1 Make sure all necessary software (provided) are
installed in your PC.
2 Set the Recording Mode Switch to “MEMORY”.
3 Set the Power Switch to “A” or “M” while
pressing down the Lock Button located on the
switch.
4 Connect the camcorder to your PC using the USB
cable.
● “ ” appears on the screen.
● If the PC is not powered on, the camcorder
does not enter the Web Camera mode.
5 When finished, turn off the PC first, then the
camcorder. Disconnect the USB cable from the
camcorder and PC.
NOTES:
● It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the
battery pack. (墌 pg. 11)
● You can also use the camcorder for video
conference over the Internet by using Microsoft
Windows
®
Messenger
®
. For details, refer to the
instruction manual of the provided software.
● In the Web Camera mode, the following buttons
cannot be operated: SNAPSHOT, INDEX, NAVI,
NAVI STORE, the Recording Start/Stop Button.
Using The Camcorder As A
WebCam
To USB
To USB connector
USB cable
(provided)
USB-equipped PC
Connector Cover*
Refer to the instruction manuals of the PC and
provided Software.
SYSTEM CONNECTIONS (cont.)
GR-PD1PAL.book Page 66 Tuesday, June 17, 2003 7:31 PM