38 EN
w
M
–
0
:
12
:
34
START/STOP
REW
PLAY
STO P
IN SERT
PAUSE
Insert editing
indicator
Display
COU N TER R/ M Button
Tape Counter
RM-V715U
Remote sensor
Power Switch
Insert Editing
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
N OTE:
Use the remote control unit to perform this procedure.
1
Set the Power Switch to “ ”.
2
Play back the tape, locate the Edit-Out point and
press PAU SE.
3
Press and hold COU NTER R/ M on the camcorder for
more than 1 second to reset the tape counter, then
press it again for less than 1 second so that “M”
appears.
4
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAU SE exactly at the Edit-In
point where the new scene should start.
5
Press and hold IN SERT, and without releasing
IN SERT, press and release PAUSE. The Insert Editing
indicator appears and the Insert Editing mode is
engaged. When the scene the camcorder is aimed at
appears on the screen, go to the next step.
6
To begin Insert Editing, press START/ STOP. When the
counter reaches “ 0:00:00” , editing stops automati-
cally and the camcorder enters the Insert-Pause
mode.
7
To end Insert Editing, press STO P.
N OTES:
●
During Insert Editing, the original audio will be heard
from the speaker.
●
After step 5, Retake (
墌
pg. 17) can be performed.
●
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
●
Only the video signal is recorded in the Insert Editing
mode.
RM-V700U
(optional)
OR
USIN G THE REM O TE CONTRO L U N IT
(GR-SXM 607/ SXM57/ SX202 only)
(cont.)
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
