Erase Proledion
Casselle holder
I
EJECT Swilch
Turn to lake
up slack.
Gear
PUSH Bullon
Loading/UnloadingA Cessette
OPEN LCD MONITOR
Open the LCD monitor to an angle of over 60
d%rees.
OPEN CASSETTE HOLDER
Slide EJECT until the holder ()pens. Do not use force
to open.
INSERT/REMOVE CASSETTE
Make snre the label is facing outward.
CLOSE CASSETTE HOLDER
Press PUSH and make snre the holder is closed and
locked.
|
N.
L_
CLOSE LCD MONITOR
First make sure the holder is closed. Then close the
LCD monitor.
NOTES:
• Closing the LCD monitor while the cassette holder is still
open may cause damage to the LCD monitor.
• The cassette holder can't be opened unless a power
supply is attached.
• Make sure that the tape is not slack when loading the
cassette. If there is any slack, turn the gear on the
cassette in the direction of the arrow to take up the
slack.
• Make sure the Erase Protection tab is in the position that
allows recording. If not, slide the tab. Some cassettes
have removable tabs. If the tab has been removed, cover
the hole with adhesive tape.
• The cassette holder cannot be opened while the
cam(order is in the record mode.
To Next Page
Loading...
