180'
LENS COVER Open/close Ring
V
Tally lamp
dights while recording is in progress)
Shoofi.gWhileWatchi.gTheLCDMo.itor
Before the following steps, perform step 1 (_ pg. 18).
ENTERRECORD-STANDBY MODE
Make sure the LCD monitor is fully open. 111rn the
tENS COVER Open/Close Ring to open the lens
cover, then set the Power Switch to "CAMERA"
("AUTO" or "PRO.").
The power lamp lights and the camcorder enters the
Record-Standby mode.
The scene you are aimed at appears in the LCD
monitor, with the word "PAUSE" superimposed
upon it.
STARTSHOOTING
Tilt the LCD monitor upward/downward for best
viewability (_ pg. 21) and press the Recording Start/
Stop Button.
® " I_I_REC,, appears in the LCD monitor while recording
is in progress.
STOP RECORDING
Press the Recording Start/Stop Button again to stop
recording.
The camcorder re-enters the Record-Standby mode.
NOTES:
• When you use the LCD monitor outdoors in direct
sunfighL the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(_ pg. J 8).
• To turn the tally lamp offdurir N recording, refer to pgs.
32 and 34.
• For other notes, refer to pg. 19.
To Next Page
Loading...
