..... i!!!!!!!!i!!!!I !!!!!!!!! iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii iEN51
indicator
Display
AudioDubbing
Yon can record a new sonndtrack on a prerecorded tape
(normal audio only).
Perform steps 1,2 and 3 of the Insert Editing procedure
(_z_ pg. 50) before continuing.
The sound comes from the built-in microphone.
Remote sensor
Microphone
FIND EDIT-IN POINT
Press REW to go a little beyond the beginrlirlg of tlme
scene onto which you want to dub the new audio,
press PLAY to view the recorded tape, then press
PAUSE at exactly the point where dubbing should
starL
ENGAGE AUDIO DUB-STANDBY MODE
Press and llold A. DUB, and witl_ont releasing
A. DUB, press and release PAUSE. The Audio Dub
standby mode is engaged. The Audio Dubbing
Indicator is displayed on the top right corner of the
LCD monitor or viewfinder.
BEGIN AUDIO DUBBING
Press PLAY. When the counter reaches "0:00:00",
Audio Dubbing stops automatically and the
camcorder enters the Audio Dub-Standby mode.
END AUDIO DUBBING
Press STOP.
RM-V705U
(provided)
NOTES:
• Do not press FF or REW during Audio Dub-Standby, or
the edit points will not be accurate.
• If the microphone is too close to the TV, or if the TV's
volume is too high, whistfing or howfing may occur.
NOT[S (for Insert [diting and
Audio Dubbing):
• Insert Editing and Audio Dubbing may not work
conectly if the tape contains blank segments, or if the
recording speed was changed during the original
recording.
• To edit/dub onto a tape, make sure the Erase Protection
tab is in the position that allows recording. If noL sfide
the tab. Some cassettes have remow_ble tabs. If the tab
has been removed, cover the hole with adhesive tape.
• Do not press STOP during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.
• During Insert Editing and Audio Dubbing, when Insert-
Pause or Audio Dub-Standby is engaged, the counter
may go slightly past "0:00:00". Recording, however,
stops at exactly 0:00:00.
To Next Page
Loading...
