JVC GZ-MG730 - Other Settings; Attaching the Shoulder Strap; Checking the Remaining Battery Power; Preparing the Remote Control

15
ENGLISH
Preparing the Remote Control
A battery is included inside the remote control
at the time of purchase.
Remove the insulation sheet before use.
Effective Beam DistanceBeam DistanceDistance
NOTE
The transmitted beam may not be effective
or may cause incorrect operation when the
remote sensor is directly exposed to sunlight
or powerful lighting.
To Reinsert the Battery
Pull out the battery holder by pressing the
lock tab.
Eyelet
Strap Guide
Buckle
Effective distance:
5 m
Remote Sensor
Lock Tab
Lithium Battery
(CR2025)
Checking the Remaining Battery
Power
Preparation:
•
Attach the battery pack.
•
Press the SELECT PLAY/REC button to
select recording mode.
For ! mode:
Press the INFO button twice or the INFO
button and then select ;.
For # mode:
Press the INFO button.
DIRECT
BACK UP
INFO
BATTERY CONDITION
MAX TIME
min
QUIT
7
To return to the normal screen
Press the INFO button again.
NOTES
•
If “COMMUNICATING ERROR” appears,
there may be a problem with your battery.
In such a case, consult your nearest JVC
dealer.
•
The recordable time display should only be
used as a guide. It is displayed in 10 minute
units.
Attaching the Shoulder Strap
Other Settings
GZ-MG530&730EK(1B)_EN.indb 15 5/2�/200� 3:59:24 PM