Open the terminal cover (SD card cover)
A
Open the LCD monitor.
B
Slide down the terminal cover
lock and slide the cover aside
C
Lift the cover slowly.
o
To close
.
Leave the LCD monitor open first.
A
Flip down the cover slowly while making sure the gray waterproof seal fits into
the opening at the terminals.
B
Press the entire cover against the camcorder with equal force and firmly attach
the cover completely.
C
Slide the cover until it clicks into place.
(The cover is not properly closed if the red mark at the terminal cover lock is
visible.)
CAUTION
0
Do not apply excessive force when opening or closing the terminal cover.
0
Do not open or close the terminal cover with wet or dirt/sand-covered hands.
0
Do not allow any dirt, lint, hair, sand, and other foreign substances to
accumulate between the waterproof seal and the case.
0
Never damage or scratch the waterproof seal and terminal cover. Doing so
can result in leaks. If the seal is damaged, contact your nearest JVC Service
Center for a replacement. (Charges apply.)
0
Read the “Detailed User Guide” carefully before using the camcorder under
water or in places exposed to water droplet.
To Next Page
Loading...
Need help?
General
