JVC GZ-R315 - Capturing Still Images During Video Recording; Taking Still Images in Auto Mode

Capturing Still Images During Video Recording
Still images can be captured by tapping the A
button while in the video mode
(standby or recording).
.
0
“PHOTO” lights up on the screen when a still image is being captured.
.
Memo :
0
The size of the still image that is captured in the video mode is 1,920 x
1,080.
0
Operation is invalid under the following conditions:
- when menu is being displayed
- when remaining recording time or battery power is being displayed
- when any functions in “TIME-LAPSE RECORDING”, “RECORDING
EFFECT” or “DATE/TIME RECORDING” is set
- when the AV cable is connected to the AV connector
- when the HDMI cable is connected and a resolution other than 1080i is
output
Taking Still Images in Auto Mode
You can record without worrying about the setting details by using the P
Intelligent Auto mode.
1
Open the LCD monitor.
.
0
Check if the recording mode is B.
0
If the mode is A
video, tap A on the recording screen to display the
mode switching screen.
Tap B to switch the mode to still image.
2
Check if the recording mode is P Intelligent Auto.
.
0
If the mode is H Manual, tap H on the recording screen to display
the mode switching screen.
Tap P to switch the recording mode to Intelligent Auto.
.
3
Press the START/STOP button.
.
0
PHOTO lights up when a still image is being captured.
Memo :
0
Depending
on the subject and shooting conditions, recording may not be
performed properly even in the Intelligent Auto mode.
o
Start recording after adjusting the focus
A
Press and hold the A button on the touch screen until the focus is
adjusted.
.
B
Remove your finger from the button to release the shutter.
Available only when “SHUTTER MODE” is set to “RECORD ONE SHOT”.
Recording
24