30 EN
Edit To Or
From Another
Video
Recorder
You can use your video recorder as the source player or the
recording deck.
MAKE CONNECTIONS
1
Connect the player’s 21-pin SCART (AV) connector to
the recorder’s 21-pin SCART (AV) connector as
illustrated on page 31.
When Using Your Video Recorder As The Source
Player . . .
. . . connect its AV1 IN/OUT connector to the recording
deck.
When Using Your Video Recorder As The Recording
Deck . . .
. . . . connect its AV2 IN/DECODER or AV1 IN/OUT
connector to the source player.
SET RECORDING DECK’S
INPUT MODE
2
Set to AUX. With this video recorder, press N UMBER
key "0" and/or TV PROG to select depending on the
connector being used — “L-1” for the AV1 IN/OUT
connector, or “L-2” for the AV2 IN/DECODER connector.
● When using the AV2 IN/DECODER connector, make
sure "AV2 SELECT" is set to "AV2" (Z pg. 31).
SET EDIT MODE
3
See "Picture Control" on page 16.
START SOURCE PLAYER
4
Engage its Play mode.
START RECORDING DECK
5
Engage its Record mode.
N OTES:
●
All necessary cables can be obtained from your dealer.
●
When you select EDIT to dub tapes in step 3, be sure to select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish
dubbing the tapes.
●
When you use this recorder as the player for editing, be sure
to set "O.S.D." to "OFF" before starting (
Z
pg. 9).
123
456
7
89
0
2
4
1
3
?
NU M BER "0"
TV PROG
OK
M EN U
EDITING (cont.)
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
