JVC HX-Z30 Service Manual

1-8 (No.MB043)
3.1.3 Removing the front panel assembly
(See Fig.6~9)
• Prior to performing the following procedure, remove the metal
cover and the CD changer mechanism assembly.
(1) Disconnect the card wires from connector CN44 and
CN870
on the main board on the right side of the body.
(2) Disconnect the wire from connector CN701
on the bridge
board.
(3) Cut the band.
(4) Disconnect the wire from connector CN231
on the primary
board on the left side of the body and remove the band
fixing the wire.
(5) Disconnect the ground wire extending from phones board
from bottom chassis.
(6) Remove the three screws D attaching the front panel
assembly at the bottom of the body.
(7) Release the two joints a on the lower left and right sides of
the front panel assembly using a screwdriver, and remove
the front panel assembly toward the front.
REFERENCE:
Front panel need to be tilt a little bit as release from bottom
chassis.
Fig.6
Fig.7
Fig.8
Fig.9
Front panel assembly
Bridge board
CN701
Main board
CN870
CN44
a
Front panel assembly
Primary board
CN231
Band
a
Ground wire
Band
Primary board
CN231
Front panel assembly
Front panel aeembly
D

JVC HX-Z30 Specifications

General

Brand	JVC
Model	HX-Z30
Category	Stereo System
Language	English