24
ENGLISH
Menu item Selectable setting/item
Fader/Balance
Fader:
Adjust the front and rear
speaker output balance.
Balance:
Adjust the left and right
speaker output balance.
♦
F06 to R06; Initial 00 (fader)
♦
L06 to R06; Initial 00 (balance)
[5/∞]: Adjusts fader.
[2/3]: Adjusts balance.
[ ]: Resets the adjustments.
• When using a two-speaker system, set the fader to the center (00).
Volume Adjust *
1
Adjust and store the auto-adjustment volume level for each source, comparing
to the FM volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix> appears when an FM broadcast is selected as the source.
♦
–12 to +12; Initial 00
Subwoofer Level
You can adjust the output level of the subwoofer when it is activated.(
17)
♦
–06 to +08; Initial 00
High Pass Filter
♦
Through
♦
On
: Select when the subwoofer is not connected.
: Select when the subwoofer is connected.
Crossover Select the crossover frequency between the front/rear speakers and the
subwoofer.
♦
80Hz, 120Hz, 150Hz
Amplifier Gain *
2
You can change the maximum volume level of this unit.
♦
Off
♦
Low Power
♦
High Power
: Deactivates the built-in amplifier.
: VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W.)
: VOL 00 to 50
Rear Speaker *
3
You can activate/deactivate the rear speakers.
♦
Off, On
*
1
For “
DISC/USB
”: You can make the adjustments separately depending on the audio format—Dolby digital and
the others.
*
2
The volume level automatically changes to “30” if you change to <Low Power> with the volume level set higher
than “30.”
*
3
This setting takes effect only when Dual Zone is activated. ( 43)
Initial: Underlined
Dragging also makes
adjustments.
EN_KDAVX7755[EE]f.indb 24EN_KDAVX7755[EE]f.indb 24 09.3.27 2:56:28 PM09.3.27 2:56:28 PM
To Next Page
Loading...
