EasyManuals Logo

JVC KD-BT1 Manual

JVC KD-BT1
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
ENGLISH
48
Symptom Remedy/Cause
USB device
Correct characters are not displayed (e.g.
album name).
For available characters, see page 4.
While playing a track, sound is sometimes
interrupted.
The tracks have not been properly copied into the USB
device. Copy tracks again into the USB device, and try
again.
The sound is interrupted or skipped during
playback of a USB device.
Turn off, then turn on the unit.
(When the sound is not yet restored,) connect the device
again.
Bluetooth
Bluetooth device does not detect the unit. The unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
The unit does not detect the Bluetooth device. Check the Bluetooth setting of the device.
Search from the Bluetooth device. After the device
detects the unit, select “Open...” on the unit to connect
the device. (See page 17.)
The unit does not make pairing with the
Bluetooth device.
Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on
its instructions, try “0000” or “1234.”
Select the device name from “Special Device,” then try to
connect again. (See page 18.)
Try to pair/connect from the Bluetooth device.
Check if your Bluetooth device support the respective
profile. (See page 16.)
Echo or noise occurs. Adjust the microphone unit position.
Phone sound quality is poor. Reduce the distance between the unit and the Bluetooth
audio device.
Move the car to a place where you can get a better signal
reception.
The sound is interrupted or skipped during
playback of a Bluetooth audio device.
Reduce the distance between the unit and the Bluetooth
audio device.
Disconnect the device connected for “Bluetooth Phone.”
Turn off, then turn on the unit.
(When the sound is not yet restored,) connect the device
again.
The connected audio device cannot be
controlled.
Check whether the connected audio device supports AVRCP
(Audio Video Remote Control Profile).
EN44-51_KD-BT1_001A_2.indd 48EN44-51_KD-BT1_001A_2.indd 48 2/7/07 11:35:58 AM2/7/07 11:35:58 AM

Table of Contents

Other manuals for JVC KD-BT1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC KD-BT1 and is the answer not in the manual?

JVC KD-BT1 Specifications

General IconGeneral
BrandJVC
ModelKD-BT1
CategoryCar Receiver
LanguageEnglish

Related product manuals