JVC KD-DV5000 - Tuning in to a Preset Station

15
ENGLISH
Selecting a preset station using the
preset station list
If you forget which stations are stored in which
preset numbers, you can check the preset
station list, then select your desired station.
1 Select the band (FM1 – 3, AM).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC.
Each time you press and hold
the button, the band changes.
2 Press and hold 5 (up) or ∞ (down)
until the preset station list for the
current band (FM1, FM2, FM3, or AM)
appears on the display.
Notes:
• If one of FM band preset station lists (FM1,
FM2, or FM3) is shown on the display, you
can show the other lists by pressing 5 (up) or
∞ (down).
• If a preset station is an FM RDS station with
PS signal, PS name will be shown instead of
the station frequency.
3 Select the number (1 – 6) for the
preset station you want.
FM1 FM2 FM3 AM
345621
SRC
FM1 FM2 FM3 AM
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on pages 13 and 14.
Selecting a preset station directly
1 Select the band (FM1 – 3, AM).
1 Press SRC (source)
repeatedly to select the tuner.
2 Press and hold SRC.
Each time you press and hold
the button, the band changes.
2 Select the number (1 – 6) for the
preset station you want.
When using the remote controller
1
Press FM (DAB) or AM.
• When selecting the FM bands,
press FM (DAB) repeatedly
until the band you want is
selected.
2 Press the number buttons (1 to 6) while
holding SHIFT (S).
Note:
You can also use the PRESET (FOLDER) 5 / ∞
buttons for selecting a preset station.
345621
SRC
AM
FM
DAB
S
SHIFT
TOP
MENU
564
23
1
DISC
ENTER
MENU
+
EN11-16DV5000[E]f.p65 03.3.23, 18:4715