JVC KD-T902BT

16
ENGLISH
Make the settings for receiving a call
1
Press
to enter Bluetooth mode.
2 Perform ‘Select an item (page3 or 4)’ operation to select an
item (see the following table).
3 Repeat step 2 until the desired item is selected or activated.
To return to the previous setting item, press
.
Default: [XX]
[SETTINGS]
[AUTO ANSWER]
[01SEC] to [30SEC]: Answers an incoming call automatically in the selected
time (in seconds). ; [OFF]: Cancels.
[RING COLOR]
[COLOR01] to [COLOR49] ([COLOR08]): Selects the illumination color for
the buttons or symbolic button as notification when there is an incoming call
and during a call. ; [OFF]: Cancels.
Make a call
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1 Press
to enter Bluetooth mode.
“(First device name)” appears.
• If two Bluetooth phones are connected, press again to switch to
the other phone.
“(Second device name)” appears.
2 Perform ‘Select an item (page3 or 4)’ operation to select an
item (see the following table).
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
To return to the previous setting item, press
.
BLUETOOTH®
[RECENT CALL] (Applicable only if the phone supports PBAP.)
1 Press the following button to select a name or a phone number.
KD-T902BT: Volume knob
KD-T901BT: VOL +/–
• “<” indicates call received, “>“ indicates call made, “M” indicates call
missed.
• “NO HISTORY” appears if there is no recorded call history or call number.
2 Press the following to call.
KD-T902BT: Volume knob
KD-T901BT:
* ENTER
[PHONEBOOK] (Applicable only if the phone supports PBAP.)
1 Press 2 J / 1 K to select the desired letter (A to Z, 0 to 9, and OTHERS).
• “OTHERS” appears if the first character is other than A to Z, 0 to 9.
2 Perform ‘Select an item (page 3 or 4)’ operation to select a name.
3 Perform ‘Select an item (page 3 or 4)’ operation to select a phone
number to call.
• The phonebook of the connected phone is automatically transferred to the
unit when pairing.
• This unit can display only non-accent letters. (Accent letters such as “Ú” are
showns as “U”.)
[DIAL NUMBER]
1 Perform the following operation to select a number (0 to 9) or character
(
, #, +).
KD-T902BT: Turn the volume knob
KD-T901BT: Press VOL +/–
2 Press S / T to move the entry position.
Repeat steps 1 and 2 until you finish entering the phone number.
3 Press the following to call.
KD-T902BT: Volume knob
KD-T901BT:
* ENTER
[VOICE] Speak the name of the contact you want to call or the voice command to
control the phone functions. (See “Make a call using voice recognition” on
page 17.)