JVC KS-DR2104DBT User Manual

■ Installation procedure
Read
the instruction manual well to
select the proper connection and set-
ting. Refer
to "Connections" on the back
side.
1. Remove
the ignition key and discon-
nect
the negative 0 terminal of the
battery to prevent short circuits.
2. Connect the battery wire.
3. Connect the ground wire to chassis
ground of vehicle.
4. Connect the power control wire.
5. Connect the speakers.
6. Connect the remote control unit.
7. Attach the unit.
8. Connect
the negative 0 terminal of
the battery.
9. Remove the Dressing panel.
1 0.Set
the unit according to the
intended usage (FADER, FILTER,
OUTPUT).
11.Fix
the Dressing panel with screws
securely.
I A CAUTION I
•
Do not install in the below locations;
(Unstable location , In a location that interferes with
driving , In a location that gets wet, In a dusty location ,
In a place that gets hot , In a place that gets direct
sunlight, In a location that gets hit by hot air)
• Do not install the unit under the carpet. Otherwise
heat build - up occurs and the unit may be damaged.
• Install this unit in a location which allows heat to
easily dissipate. Once installed, do not place any object
on top of the unit.
• The surface temperature of the amplifier will become
hot during use. Install the amplifier in a place where
people, resins , and other substances that are sensitive
to heat will not come into contact with it.
• When making a hole under a seat, inside the trunk,
or somewhere else in the vehicle, check that there
is nothing hazardous on the opposite side such as a
gasoline tank , brake pipe , or wiring harness , and be
careful not to cause scratches or other damage.
• Do not install near the dashboard, rear tray , or air bag
safety parts.
• The installation to the vehicle should securely fasten
the unit to a place in which it will not obstruct driving.
If the unit comes off due to a shock and hits a person or
safety part , it may cause injury or an accident.
• After installing the unit , check to make sure that elec-
trical equipment such as the brake lamps , turn signal
lamps and windshield wipers operate normally.
• In order to secure the Water-proof & Dust-proof per-
formance (IP67&1P66) of this product, use it with the
dressing panel firmly attached. If the dressing panel is
not installed properly, dust and water may enter and
cause a malfunction.
'$ "
~ -._-=----- Dressing panel/ Panneau d'habillage / Panel de rectificaci6n
~

JVC KS-DR2104DBT Specifications

General

Brand	JVC
Model	KS-DR2104DBT
Category	Amplifier
Language	English