JVC KW-NX7000 User Manual

I
I
Before operations
Touch panel
Touch panel
00 c::::::J C) 0 ..lye 0 c:::J ~ 0
I
Monitor panel
Map screen
In the explanation, operating buttons shown on the touch panel are indicated inside [ ].
For details on the touch panel operations, see each section.
\.
Features of the illumination _
Monitor panel buttons
The lights of the monitor panel buttons are turned off
when no operation is done for about 5 seconds.
They are turned on again in the following cases:
- When you touch the touch panel or move your hand
nearby*
- When you use the remote controller
- When a call/Text Message comes in (for Bluetooth
cellular phone)
The lights of the monitor panel buttons are always
turned on in the following cases:
- While operating buttons are displayed on the
map screen.
- While AV menu screen is displayed.
- While <Source Menu> screen is displayed.
- While <OpenlTilt> menu is displayed.
- When <Illumination> is set to <Normal>.
(~page 108)
* Depending on the <Illumination> setting.
(~page 108)
Screen
While the unit is turned on, you can turn off the screen
by holding DISP.
[11
00
c::::::J C) O..lYCo c:::J ~ 0
1
~
1''--_--,
~
The screen is turned on again in the following cases:
- When you touch the touch panel
- When you press MAP on the monitor panel or press
DISP
- When a ca II IT ext Message comes in (for Bluetooth
cellular phone)
- When the signal from the rear view camera comes in
5
INTRODUCTION

JVC KW-NX7000 Specifications

General

Auto	Yes
Marine (chartplotters, sounders)	No
Form factor	Fixed
Display diagonal	7 \
Display resolution	336 x 960 pixels