JVC KW-NX7000 User Manual

Subscribe to traffic services. 1& [47]
Selectable settings, [reference pagel
Edit the voice message at startup/shutdown of the System.
• To edit the message, press [Edit], enter the message, then press [OK].
You can listen to the edited message by pressing [Test].*3
( The procedure for setting an item is shown on page 16. )
Initial: Underlined
Select this to update your map database using an SD card.
• When you press [Open the Front Panel], the front panel opens. Press
[Cancel] to cancel the operation.
• For details about updating your unit, visit <http://www.jvc-exad.com>
(English website only).
The Navigation System is gradually optimized by automatic calibration.
Reset the calibration data in the following cases:
• When you reinstall the unit in another car.
• When you replace or rotate the tires.
Once this is carried out, the calibration data is cleared.
• When you press [Reset], a confirmation message appears. Press [Yes]
to confirm the operation. Press [No] to cancel.
Initializes all your settings.
• When you press [Restore], a confirmation message appears. Press [Yes]
to confirm the operation. Press [No] to cancel.
Favorite*l: Initializes the list of your favorite points. 1& [24]
Previous*l: Initializes the list of previous destinations and via points. 1&
[36]
Home*l: Initializes the registration of your home. 1& [24]
If you find your current position displayed on a wrong place on the map,
use this setting to correct your position.
• To change your position, move the cursor to the position where you
want to set as current position and press [OK], then adjust the direction
by pressing [8]/(6] and press [OK].
Function Menu-Map Settings (continued)
*1 Selectable only when at least one place is registered.
*2 You cannot use Cyrillic characters for the message.
*3 For entering the characters, 1& page 28.
52

JVC KW-NX7000 Specifications

General

Auto	Yes
Marine (chartplotters, sounders)	No
Form factor	Fixed
Display diagonal	7 \
Display resolution	336 x 960 pixels