JVC KW-V820BT - Audio Sound Adjustment; Speaker and Crossover Frequency Settings

ENGLISH 51
SETTINGS
Sound adjustment—Audio
You can adjust the various audio settings on the
<Audio> screen.
t You cannot change the <Audio> settings screen
in the following situations:
– When the AV source is turned off (Page6)
– When the Bluetooth phone is used (making
or receiving a call, during a call, or while voice
dialing)
R Setting the car type/speakers/crossover
frequency
1 Display the source/option selection screen.
On the Home screen:
t You can also display the source/option
selection screen by touching [
] on the
source control screen.
2 Display the <Audio> screen.
3 Display the <Speaker Select> screen.
4 Select a car type.
A selection window appears for car type. Select
an item, then touch [Close] to close the window.
5 Select a speaker (front speakers, rear
speakers, or subwoofer) to set (1), then
location and speaker/tweeter size of the
selected speaker (2).
A selection window appears for location and
speaker/tweeter setting. Select an item, then
touch [Close] to close the window.
t Repeat steps 1 and 2 to set all speakers.
t When a speaker is not connected, select
[None].
t When setting the front speakers, also select
the speaker size for <Tweeter>.
6 Display the <X’over> screen (1), select
the speaker type (2), then adjust the
crossover frequency of the selected
speaker (3).
<HPF FREQ> Adjusts the crossover frequency
for the front or rear speakers
(high pass filter).*
1
<LPF FREQ> Adjusts the crossover for the
subwoofer (low pass filter).*
2
<Slope> Adjusts the crossover slope.*
3
<Gain> Adjusts the output volume of
the selected speaker.
<TW Gain> Adjusts the output volume of
the tweeter.*
4
*
5
<Phase> Selects the phase for the
subwoofer.*
2
*
1
Appears only when the front or rear speakers are selected.
*
2
Appears only when the subwoofer is selected.
*
3
Not adjustable when <HPF FREQ> or <LPF FREQ> is set to
<Through>.
*
4
Appears only when the front speakers are selected.
*
5
Adjustable only when <Tweeter> is set to <Small>,
<Middle>, or <Large> on the <Speaker Select>
screen.