(No.YA711<Rev.002>)1-17
4.9 FIRMWARE RENEWAL MODE
4.9.1 DVD SECTION
(1) Turn the power on and press [EJECT] button on the remote
control unit to put the LCD TV/DVD into DVD mode. Then
remove the disc.
(2) To put the LCD TV/DVD into F/W version up mode, press
[9], [8], [7], [6], and [MODE] buttons on the remote control
unit in that order.
Fig. a appears on the screen.
(3) Insert the disc for version up into the disc slot.
(4) The LCD TV/DVD enters the F/W version up mode auto-
matically. Fig. b appears on the screen. Make sure to insert
the proper F/W for the state of this model.
The appearance shown in (*1) of Fig. b is described as fol-
lows:
(5) After programming is finished, the disc will be ejected auto-
matically. Fig. c appears on the screen and the checksum
will be shown in (*2).
At this time, no button is available.
(6) Remove the disc.
(7) Unplug the AC cord from the AC outlet. Then plug it again.
(8) Press [EJECT] button on the remote control unit to put the
LCD TV/DVD into DVD mode again.
(9) Press [1], [2], [3], [4], and [INFO] buttons on the remote
control unit in that order. Fig. d appears on the screen.
(10) Press [CLEAR] button on the remote control unit. Fig. e ap-
pears on the screen.
When “OK” appears on the screen, the factory default will
be set. Then the firmware renewal mode is complete.
(11) To exit this mode, press [CHANNEL UP/DOWN] button to
go to TV mode, or press [POWER] button to turn the power
off.
No. Appearance State
1 Reading... Sending files into the memory
2 Erasing... Erasing previous version data
3 Programming... Writing new version data
Fig. a Version Up Mode Screen
F/W Version Up Mode Model No : ******
VERSION : *.**
Please insert a DISC
for F/W Version Up.
EXIT: SELECT
"
*******
" differs depending on the models.
Fig. b Programing Mode Screen
VERSION : ************.***
Reading...
F/W Version Up Mode Model No : ******
VERSION : *.**
"
*******
" differ depending on the models.
(*1)
Fig. c Completed Program Mode Screen
VERSION : ************.***
Completed
SUM : ****
F/W Version Up Mode
Model No : ******
VERSION : *.**
"
*******
" differ depending on the models.
(*2)
Fig. d
MODEL : ******
Version
: *.**
Region
: *
EXIT: SELECTEEPROM CLEAR : CLEAR
"
*******
" differs depending on the models.
Fig. e
MODEL : ******
Version
: *.**
Region
: *
EEPROM CLEAR : OK
EXIT: SELECTEEPROM CLEAR : CLEAR
"
*******
" differs depending on the models.
To Next Page
Loading...
