English - 9 -
Inserting the Batteries into the Remote
Lift the back cover up to open the battery compartment
of the remote control. Observe the correct polarity (+/-)
when inserting batteries. Replace the cover.
Batteries should not be exposed to excessive heat
such as sunshine, re or the like.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable Connection
Connect the “aerial” or “cable TV” plug to the AERIAL
INPUT (ANT) socket located on the back of the TV.
Specications(TV)
TV Broadcasting PAL B/G D/K K
Receiving Channels
VHF (BAND I/III) - UHF
(BAND U) - HYPERBAND
Number of Preset
Channels
1000
Channel Indicator On Screen Display
RF Aerial Input 75 Ohm (unbalanced)
Operating Voltage 220-240V AC, 50Hz.
Audio German+Nicam Stereo
Audio Output Power
(WRMS.) (10% THD)
2 x 2,5 W
Power Consumption 45W
Weight (kg) 5,15 kg
TV Dimensions WxHxD
(with stand) (mm)
530 x 376 x 135
TV Dimensions WxHxD
(without stand) (mm)
530 x 340 x 55
Operation temperature
and operation
humidity:
5ºC up to 45ºC, 85%
humidity max
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
