What to do if my JVC LCD TV has no picture?
If your JVC LCD TV shows no picture, the brightness and contrast levels might be set too low. Also, make sure the source type is correctly selected. Try increasing the brightness and contrast settings and selecting the proper source input.
What to do if my JVC LCD TV remote is not working?
If your JVC LCD TV remote isn't working correctly or has a short range, the batteries may be exhausted, there might be an obstacle blocking the signal, or the remote control sensor on the TV could be dirty. Try inserting new batteries, removing any obstacles and aiming the remote straight at the sensor with a clear line of sight, and cleaning the remote control sensor lens on the TV with a soft cloth.
How to fix grainy picture on JVC LT-32HA48U LCD TV?
A grainy or snowy picture on your JVC LCD TV could be caused by a faulty video recorder, transmitter trouble, or issues with your aerial (moved, damaged, or disconnected). If you have a video recorder, try plugging the aerial directly into the television. If the picture clears, the video recorder is likely faulty. It is also recommended to have your aerial system checked.
How to stop picture interference on JVC LT-32HA48U?
Picture interference on your JVC LCD TV, like spots or streaks, can be due to a weak aerial signal, interference from electrical equipment, or mismatched settings for digital video equipment output. Try tuning in a better signal from the same television station and have your aerial system checked. Move any interfering equipment further away or turn it off. If possible, adjust the refresh rate or resolution settings on the digital equipment.
Why does my JVC LCD TV have extra outlines on objects (ghosts)?
Extra outlines or 'ghosts' on objects in the picture of your JVC LCD TV can occur because the aerial is receiving reflected signals from hills or buildings, or due to a faulty aerial system. Try to tune in a better signal from the same television station. Consider getting your aerial system checked.
How to resolve crackling noises on JVC LCD TV?
Crackling noises or distorted sound on your JVC LCD TV can be caused by interference from cars, fluorescent lights, video recorders, radio broadcasts, personal computers, or other equipment. Turn off one piece of equipment at a time to see if the interference clears. Refer to the solutions for picture interference as well.
What to do if my JVC LT-32HA48U LCD TV is stuck on stand-by?
If your JVC LCD TV does not respond to remote or local controls and is 'stuck' on stand-by, the micro-controller may be confused by an electrical disturbance. Switch off the main power and wait five minutes before trying again.
Why does my JVC LT-32HA48U LCD TV picture look squashed or stretched?
If the picture on your JVC LCD TV looks squashed or stretched even when the aspect ratio controls are correctly set, the equipment feeding the display might be set to the wrong aspect ratio. On the equipment connected to the TV, choose the correct output aspect ratio, such as 4:3 (old conventional) or 16:9 or 1280 x 720 or 1920 x 1080 pixels to match wide screens.
Why is my JVC LCD TV picture too dark, too light, or tinted?
If the picture on your JVC LCD TV is too dark, too light, or tinted, it could be due to incorrect color or brightness adjustments in the menu. Adjust the saturation and brightness in the menu settings.
What causes stereo to switch to mono on JVC LT-32HA48U?
If your JVC LCD TV's audio switches from stereo to mono, it could be due to a weak signal or a mono broadcast. Check the signal strength and your aerial system.
To Next Page
General
