EN 16
CH /
Press and release CH / . The channel
automatically stops at the next channel set into
memory.
For proper operation, before selecting channels, they
should be set into the memory. See “Channel setup”
on page 20.
DISPLAY
Press DISPLAY to display the current information on
the screen.
When the TV receives a digital signal, the digital
information will appear.
3_ARTE_Monosco_0820_0000_0030_Audio6_ABCDEFGHIJKLMNOPQ
RSTUVWXYZabcdefghijklmnopqrstuvwxyz_ABCDEFGHIJKLMNOPQR
STUVWXYZabcdefghijklmnopqrs tuvwxyz_ABCDEFGHIJKLMNOPQRS
TUVWXYZabcdefghijklmnopqrs
Digital Air
15-1
CC Off
CH-1
480i Audio 2/3
CC
SD
2013/01/01 17:10 PM
Good
TV-14-D
Monoscope_480i_1
Channel number• DTV Signal condition•
Channel label (if preset)•
Broadcast program name
•
V-Chip rating• Current date and time•
Program guide• Audio language•
Resolution• Closed Caption•
Press DISPLAY again to clear the call display.
NOTE:
After a few seconds, DISPLAY screen will return to
normal TV operation automatically.
SLEEP
To set the TV to turn off after a preset amount of time,
press SLEEP on the remote control. The clock will
change for each press of the SLEEP button (Off, 5
min, 10 min, ..., 240 min).To confirm the sleep timer
setting, press SLEEP and the remaining time will
be displayed for a few seconds. To cancel the sleep
timer, press SLEEP repeatedly until the display turns
to Off.
•
Quick guide for menu
operation
Call menu and for example: Select Language.
1
Press INPUT SELECT to select TV mode.
2
Press MENU. The TV menu screen will appear.
Picture Preference
Picture Sound Time Setup Lock Channel
Brightness
Standard
Standard
Contrast
Color
Tint
Sharpness
50
50
50
50
50
Color Temperature
Advanced Settings
3
Press ◀ or ▶ to select “Setup”, then press ▼.
4
Press ▲ or ▼ to select “Language”, then press ◀
or ▶ to select the desired language.
…on the following pages the menu can be called
in the same way as here.
5
Press MENU to return to the previous screen.
NOTE:
If no buttons are pressed for more than about 30
(depending on your setting) seconds, the menu
screen will return to normal operation automatically.
During TV or external input mode (except PC
input mode), if there is no signal reception with
no operation, the TV will change to standby after
approx. 15 minutes (in PC input mode: 1 minute).
•
•
J3RF0321A_EN.indd 16J3RF0321A_EN.indd 16 3/1/13 9:24:53 AM3/1/13 9:24:53 AM
To Next Page
Loading...
Need help?
General
