45
Technical information
Receivable broadcast systems
The broadcast system that can be received by “Auto Scan” will differ by
countries.
FRANCE: Can receive SECAM-L.
To register channels that cannot be received by using “Auto Scan” because
of the broadcast system, use “Manual Scan”.
Auto in “Zoom”
When “Auto” is selected in Zoom, the aspect ratio will turn to the ratio
obtained from the information the TV received.
The aspect ratio will turn to the ratio obtained from WSS (Wide Screen
Identication Signal), video signal, or control signal of the external
devices. Without receiving the aspect information, it will be the setting in
“4:3 Aspect Setting”. (P. 32)
Digital channels that cannot be watched on this TV
If a digital channel service uses new formats (such as DVB-H or MPEG4,
etc.), or MHP, it cannot be watched even though the channel name appears.
If the channel is selected, the picture will not appear and audio cannot be heard.
This TV can receive digital terrestrial broadcasting (DVB-T) in the
following countries. Digital terrestrial broadcasting (DVB-T) reception in
other countries is not guaranteed.
Austria, Denmark, Finland, France, United Kingdom, Germany, Italy,
Netherlands, Spain, Sweden, Switzerland, Czech Republic, Belgium
*
Monitor out (EXT-1, EXT-2)
To record Digital / Analogue channels to external devices
Connect the external device to EXT-1 or EXT-2.
Select a programme you want to record and video / audio will output as
an analogue signal.
Analogue channel video / audio will output from EXT-1 when analogue
channel or EXT-1 is selected.
To record video and audio from another external devices
Connect the external device to EXT-1 or EXT-2.
Select an external device you want to record and video / audio will output
as an analogue signal.
Set the aspect ratio to “Regular” or “Full”. The aspect ratio will not be
displayed correctly during recording or playback.
You cannot output from EXT-1 if you switch to EXT-1 from digital channel.
1080p (1125p) signal is not supported, because they cannot be converted
to composite signal.
Note
To Next Page
Loading...
Need help?
General
