20
Basic Operation
Menu Operation
1 Input Setup
Press INPUT key on the remote control to enter "INPUT SOURCE" menu.
Use t/u key to select an input source and press ENTER key to confirm.
2 Channels Selection
There are four ways to select channel:
1) Using number keys, and “ENTER” keys on the remote control to select channel directly.
To select channel 90, press .
When you use the number buttons, you can directly select channels that were either erased or
not memorised.
2) Using CH t/u key on the remote control or on your TV to select channel.
When you press the CH t/u key, the TV changes channels in sequence. You will see all the
channels that the TV has memorised.
You will not see channels that were either erased or not memorised.
3) Press RECALL key to return to previous channel, press it again to return to current channel.
To quickly switch between two channels that are far apart, tune to one channel, then use the
number keys to select the second channel. Then use the RECALL button to quickly alternate
between them.
RECALL is not activated if no channel has been changed after TV turning on.
4) Select channels from "Channels List" or "Favorite List".
Press “ENTER” key to choose from "Channel List" menu.
3 Volume Adjustment and Mute Setup
Volume adjustment
Press VOL+ / key on the remote control or the TV to display "Volume" menu, adjust the volume -
of TV between 0 to 100 by using VOL+ / key: -
9
0
ENTER
ut
DVBT
HOME
ATV AV
Component
HDMI 1 HDMI 2
Component
HDMI 1 HDMI 2
HDMI 3
USB
Home
To Next Page
Loading...
Need help?
General
