JVC MX-J30 - Page 41

mRemoving
the
actuator
motor
and
belt
(See
Fig.18~21)
1.
Remove
the
two
screws
10
retaining
the
gear
bracket
(See
Fig.19).
2.
While
pressing
the
pawl
“P”
fixing
the
gear
bracket
in
the arrow direction, remove the gear bracket
(See Fig.19).
3.
From
the
notch
“Q
section”
on
the
chassis
assembly
fixing
the
edge
of
gear
bracket,
remove
and
take
out
the
gear
bracket(See
Fig.
20).
4.
Remove
the
belts
respectively
from
the
right
and
left
actuator
motor
pulleys
and
pulley
gears(See
Fig.
19).
5.
After
turning
over
the
chassis
assembly,
remove
the
actuator
motor
while
spreading
the
four
pawis
“R”
fixing
the
right
and
left
actuator
motors
in
the
arrow
direction(See
Fig.
21).
[Note] When the chassis assembly is turned over under
the conditions wherein the gear bracket and belt
have been removed, then the pulley gear as well
as the gear, etc. constituting the gear unit can
possibly be separated to pieces. In such a case,
assemble these parts by referring to the assembly
and configuration diagram in Fig. 22.
Gear bracket
Fig.19
Assembly
and
Configuration
Diagram
Pulley gear Belt
MX-J30/MX-J330/MX-J35R
Gear bracket
Pulley gear
Belt
Motor pulley
Motor pulley
Fig.18
Actuator motor
Cylinder gear
Select
gear
Gross
gear
U
Gross
gearL
GearC
Fig.21
2-21