JVC MX-J300 - Common Operations; Setting the Clock

MX-J300
1-14
Remove the two screws X on both sides of the multi
control assembly.
Disconnect the card wire from connector CN705 on
the display board.
Pull outwards the joints l on both sides and detach
the multi control assembly toward the front.
1.
2.
3.
<Rolling panel assembly>
Removing the multi control assembly
(See Fig.34 to 36)
Prior to performing the following procedure, remove
the multi control assembly.
Remove the six screws Y attaching the cover and
the bracket.
Release the hooks m on both sides of the panel
holder attaching the bracket and pull out the panel
holders outward.
Detach the multi control board with the cover and the
bracket attached.
Remove the two screws Z attaching the multi control
board.
1.
2.
3.
Removing the multi control board
(See Fig.37 to 39)
Prior to performing the following procedures, remove
the metal cover the CD changer mechanism
assembly, the front panel assembly and the rolling
panel assembly.
It is not necessary to remove the display board.
Fig.36
Fig.35
Fig.34
Fig.37
Multi control assembly
X
Multi control assembly
X
Multi control assembly
Joint l
Y
Cover
CN705
Bracket
Y
Y
Bracket
Fig.39
Fig.38
Bracket
Hook m
Z
Panel holder
Multi control board
CN705