JVC MX-J300 - Page 22

MX-J300
1-22
Unsolder the head wire from the cassette
mechanism board.
Remove the two screws A retaining the R/P head
assembly.
1.
2.
< Cassette mechanism section >
Removing the R/P head assembly
(See Fig.1to2)
Loosen the screw B attaching the P/B head.
Remove the screws C retaining the R/B head
assembly.
1.
2.
Removing the R/B head assembly
(See Fig.3)
Pull the tab a outward and remove the pinch roller
upward.
1.
Removing the Pinch roller assembly
(See Fig.4)
Fig.1
Fig.3
Fig.2
Fig.4
R/P head assembly
B
A
A
Pinch roller
Sold part
Cassette mechanism board
C
Tab a
Refer to the figure for soldering