JVC MX-K50 - Page 17

1-17
MX-K50
< Speaker section >
It is exchange in a unit.
Please do not decompose as much as possible.
Remove the four bosses and duct, and remove the
front panel.
Notes:
It will be good to use the tool with a flat tip, since it is hard
to remove. Please take care not to damage the cabinet at
this time.
1.
Removing the front panel
(See Fig. 1 and 2)
Prior to performing the following procedure, remove
the front panel.
Remove the cord from the speaker terminal.
Remove the two screws A attaching the tweeter on
the front panel (inner side).
Notes:
Squawker cannot be removed.
1.
2.
Removing the tweeter (See Fig. 2)
Prior to performing the following procedure, remove
the front panel.
Remove the four screws B attaching the woofer and
remove the woofer.
Remove the cord from the speaker terminal.
Remove the capacitor pasted up on the woofer.
1.
2.
3.
Removing the woofer (See Fig. 2 and 3)
Fig.1
A
B
Fig.2
The tool with
a flat tip
Boss
Tweeter
Duct
Code
Squawker
Code
Capacitor
Woofer
Woofer (reverse side)
Front panel
Front panel
Speaker terminal
Speaker terminal
Packing