1-8 (No.MB434)
3.1.6 Removing the front panel assembly
(See Fig.9 to 10)
• Prior to performing the following procedures, remove the top
cover.
• Also remove the CD changer unit.
(1) Disconnect the parallel wire and the cord wire from the con-
nectors CN701
, CN101 on the power amp. board.
(2) Remove one screws H retaining the front panel assembly
onto the bottom of the body.
(3) Remove two screws I on the front cabinet and bottom cab-
inet and then remove then GND lug b that comes from the
power amp and supply board.
(4) Disengage the claws c on both sides of the front panel as-
sembly and then remove the assembly.
Fig.9
Fig.10
I
H
Claw
c
GND lug
b
GND lug
a
To Next Page
Loading...
