21
Troubleshooting
If you are having a problem with your System, check this list for a possible solution before calling
for service.
General:
Power does not come on.
Power plug is not inserted securely. Plug in securely. (P.4)
Adjustments or settings are suddenly cancelled before you finish.
There is a time limit. Repeat the procedure again.
Operations are disabled.
The built-in microprocessor may malfunction due to external electrical interference. Unplug
the AC power cord and then plug it back in.
Unable to operate the System from the remote control.
The path between the remote control and the remote sensor on the System is blocked.
Point it at the remote sensor on the font panel.
Signals cannot reach the remote sensor.
More closer to the System.
The batteries are exhausted.
No sound is heard from the speakers.
Speaker connections are incorrect or loose. (P.4
– 5)
Headphones are connected. (P.6)
iPod/USB Mass Storage Class Device Operations:
The iPod doesn’t play back although the display indicates CONNECT.
The battery is empty. Let stand for more than approximately 10 minutes on the connecting
condition.
Radio Operations:
Hard to listen to broadcasts because of noise.
Antenna connection is incorrect or loose. (P.4
– 5)
The FM antenna is not properly extended and positioned. (P.4
– 5)
Timer Operations:
Daily Timer does not work.
Timer starts working only when the System is turned off (standby). (P.11
– 12)
There might have been a power failure.
Set the clock first, then the timer again.
NX-PS2[A].BOOK Page 21 Friday, April 20, 2007 8:36 PM
To Next Page
Loading...
Need help?
General
