JVC NX-PS2

22
Specifications
Accessories
See page 3
Amplifier
Output Power
Main Speaker 10 W per channel, min. RMS,
driven into 6 Ω at
1 kHz, with no more than
10% total harmonic distortion
(IEC268-3)
Subwoofer 30 W, min. RMS, driven into
8 Ω at 100 Hz, with no more
than 10% total harmonic
distortion (IEC268-3)
Terminals
AUX
Input Sensitivity/Impedance (1 kHz)
LEVEL1 500 mV/47 kΩ
LEVEL2 125 mV/47 kΩ
USB MEMORY Ver. 2.0 Full Speed
Compatible device Mass Storage Class
Compatible file system FAT16, FAT32
Bus power supply Max. 5 V/500 mA
iPod
Compatible iPod types See page 13
Bus power supply Max. 5 V/500 mA
VIDEO OUT (For iPod) Composite
Speaker terminals Main speaker 6 Ω – 16 Ω
Subwoofer 8 Ω
– 16 Ω
PHONES 32 Ω
– 1 kΩ
15 mW/ch output into
32 Ω
Tuner
FM tuning range 87.50 MHz – 108.00 MHz
Unit
Dimensions 90 mm × 96 mm × 147 mm
(W/H/D)
Mass Approx. 0.62 kg
Speaker Specifications
Main speaker SP-NXPS2F (each unit)
Type Full range bass-reflex type
Speaker Unit 7.5 cm cone × 1
Power handling Capacity 10 W
Impedance 6 Ω
Frequency Range 150 Hz
– 20 kHz
Sound pressure level 83 dB/W • m
Dimensions 90 mm × 96 mm × 90 mm
(W/H/D)
Mass Approx. 0.63 kg
Subwoofer SP-NXPS2W
Type Bass Reflex Type
Speaker Unit 16 cm cone × 1
Power handling Capacity 30 W
Impedance 8 Ω
Frequency Range 35 Hz
– 150 Hz
Sound pressure level 80 dB/W • m
Dimensions 221 mm × 221 mm ×
222 mm (W/H/D)
Mass Approx. 3.5 kg
Power Specifications
NX-PS2 (System)
Power Requirements
AC 110 V – 240 V
50 Hz/60 Hz
Power Consumption 19 W (power on mode)
5 W (in Standby mode)
1 W (in ECO mode)
12 W (in Standby mode, with
iPod and USB MEMORY
connected.)
AC Adaptor (AA-R2401)
INPUT AC 110 V
– 240 V
50 Hz/60 Hz 1.5 A
OUTPUT DC 23 V 2.5 A,
57.5 VA
CA-NXPS2 (Main unit)
Power Requirements DC IN 23 V 2.5 A
Design and specifications are subject to change with-
out notice.
NX-PS2[A].BOOK Page 22 Friday, April 20, 2007 8:36 PM